References
New build or renovation — measured consumption figures from lived-in homes
Seven reference sheets from Germany and Austria: the starting point, the system installed, the costs and the heating’s actually measured electricity consumption. The results are right here on the page; the original sheets are available as PDFs at the end.
What the figures mean
Each value was measured with an electricity meter. Heating electricity is the part of the consumption attributable to the heating: most houses have a single meter, so household electricity, hot water and other loads have been deducted — partly measured, partly estimated. Each reference sheet states how.
kWh/m²a is the heating electricity per square metre of heated area and year. Where an energy certificate, a comparable neighbouring house or a second heating system in the same house was available, the comparison value is shown alongside.
Three results from the measurements
All references at a glance
The short version for each building. The detailed references with starting point, solution and costs follow below.
| Reference | Location | Building | System | Heated area | Measuring period | Heating electricity | kWh/m²a | Comparison |
|---|---|---|---|---|---|---|---|---|
| 1 | Litzelsdorf (AT) | Detached house, new build 2020, timber frame | Comfort underfloor heating (carbon) | 109.10 m² floor area | 01.07.2020–30.06.2021 | 2,672 kWh | 24.49 | Energy certificate: 51.08 kWh/m²a |
| 2 | Grabenstätt (DE) | Detached house, new build 2018, 24 cm brick | Heated parquet | 214 m² | end Oct 2020–end June 2021 | 9,538 kWh | 44 | Neighbouring house with air-to-water heat pump: 49 kWh/m²a |
| 3 | Neusiedl am See (AT) | Flat, built 1955, converted 2019 | Comfort underfloor heating (carbon) | 90 m² floor area | 17.07.2020–16.07.2021 | 3,259 kWh | 36.21 | Energy certificate: class B |
| 4 | Litzelsdorf (AT) | Detached house “O.K. Energie Haus”, new build 2018 | Comfort underfloor heating | 178 m² | one year (sheet dated Jan 2020) | 5,878 kWh | 33 | — |
| 5 | Grabenstätt (DE) | Detached house, new build 2018, 24 cm brick | Comfort underfloor heating | 214 m², of which 136 m² heated continuously | 25.10.2019–03.04.2020, extrapolated to a full year | 3,761 kWh | 17.58 (on 214 m²) / 27.65 (on 136 m²) | — |
| 6 | St. Michael im Burgenland (AT) | Detached house c. 1900, 40 cm brick without insulation | Heated parquet on the ground floor | 53.15 m² | 01.07.2019–30.06.2020 | 3,392 kWh | 61.93 | District heating in the same house: 162.11 kWh/m²a |
| 7 | near Konstanz (DE) | Detached house, new build, 36.5 cm perforated brick without external insulation | IReWA comfort underfloor heating (full carbon) | 220 m² | 06.10.2018–07.10.2019 | 8,895 kWh | 40.43 | — |
Source: reference sheets 1–7 (January 2020 to October 2021), available as PDFs at the end of this page. Heating electricity = measured electricity consumption minus household electricity, hot water and other loads as stated on the sheet. References 2 and 5 describe the same house in two different measuring periods.
Detached house in Litzelsdorf, Burgenland
Starting point: Detached house, built in 2020 in timber-frame construction, 109.10 m² floor area, two occupants.
Solution: Comfort carbon underfloor heating. Hot water from an electric boiler (100 l a day, 50 °C).
Costs: In the measuring year, the total electricity purchased — 6,872 kWh — cost €1,402. Of this, €545 was for heating, €347 for hot water and €510 for household electricity.
Measured results: Measuring period 01.07.2020 to 30.06.2021. The heating used 2,672 kWh, which is 24.49 kWh per square metre of floor area. The energy certificate assumes 51.08 kWh/m²a — the measured value is roughly half.
We have never been this comfortably warm in our whole lives.
Occupant, Litzelsdorf
Detached house in Grabenstätt, Chiemgau
Starting point: Detached house built in 2018, walls of 24 cm filled brick, KfW Efficiency House 55, 214 m² heated living space. Floor coverings: parquet and tiles.
Solution: Carbon underfloor heating as heated parquet. All heating circuits run through a dedicated meter, so consumption can be read directly.
Measured results:
Two measurements on the same house:
- 25.10.2019 to 03.04.2020 (reference 5): 3,058 kWh of heating electricity, extrapolated by 23 % for April to October to 3,761 kWh a year. That is 17.58 kWh/m²a on 214 m² — or 27.65 kWh/m²a on the 136 m² that were heated continuously. The sheet notes that the figures will be updated.
- End of October 2020 to end of June 2021 (reference 2), according to the occupant the coldest and longest winter in years: 9,538 kWh, i.e. 44 kWh/m².
For comparison, a neighbouring house in the same village, built in 2016 in insulated timber-frame construction, KfW Efficiency House 39, 175 m², with an air-to-water heat pump: 8,623 kWh in the same period, i.e. 49 kWh/m². Despite the more efficient construction, consumption per square metre was around 10 % higher.
In everyday life: Heats up in about an hour, no boiler room needed, no maintenance — whereas the heat pump next door needs regular servicing.
A really luxurious heating system that is very easy to use. What I like most is the fast heat-up time of about an hour and the small loss of space, because I don’t need a boiler room.
Occupant, Grabenstätt
Flat in Neusiedl am See, renovation
Starting point: 90 m² flat on the first floor of a 1955 building, converted in 2019. External walls of 25 cm brick with 10 cm EPS insulation, triple-glazed windows. Share in a community photovoltaic system on the roof (4.2 kWp) and a battery, 13 % each.
Solution: Comfort carbon underfloor heating, installed by Grüner Wohnen.
Measured results: Measuring period 17.07.2020 to 16.07.2021, one occupant, room temperature at least 24 °C. Total electricity purchased 5,059 kWh, of which 1,800 kWh household electricity and 3,259 kWh for heating — 36.21 kWh per square metre. The energy certificate, calculated for 20 °C, rates the flat class B; despite 24 °C, the measured value is also in class B.
Low heating costs and super easy to use — very satisfied.
Occupant, Neusiedl am See
“O.K. Energie Haus” in Litzelsdorf
Starting point: Detached house, new build 2018, 178 m² heated living space. Floor coverings: parquet and tiles. Central ventilation system, hot water from an electric boiler.
Solution: Comfort carbon underfloor heating combined with a photovoltaic system (5,500 kWh yield a year, of which 2,240 kWh self-consumed and 3,260 kWh fed into the grid).
Costs: At €0.18 per kWh, the heating would have cost €1,058.04 a year without photovoltaics. With the system, €654.84 remained for grid electricity; after deducting the feed-in tariff (€0.06 per kWh), €459.24.
Measured results: Total electricity 11,298 kWh (9,058 kWh from the grid, 2,240 kWh from the own roof). After deducting household electricity (estimated 2,500 kWh), hot water (2,555 kWh) and ventilation (365 kWh), 5,878 kWh remain for heating — 33 kWh per square metre and year.
Old house in St. Michael im Burgenland
Starting point: Detached house, built around 1900. 40 cm brick masonry without external insulation, no cellar, double-glazed windows — poorly insulated overall.
Solution: Heated parquet was laid on the ground floor (53.15 m²); the other floors (134.48 m²) continue to be heated by district heating. This allows both systems to be compared in the same house in the same year.
Costs: Heating costs per square metre and year: €12.08 with heated parquet (electricity at €0.195 per kWh) versus €15.51 with district heating (€0.0957 per kWh gross including standing charge).
Measured results: Measuring period 01.07.2019 to 30.06.2020. Heated parquet: 3,392 kWh, i.e. 61.93 kWh/m²a. District heating: 21,800 kWh excluding hot water, i.e. 162.11 kWh/m²a. Per square metre, the heated parquet therefore needs 38.2 % of the energy of district heating — district heating 2.62 times as much.
New build on Lake Constance near Konstanz
Starting point: Detached house, new build with 220 m² heated living space. Well-insulated exposed roof structure with ceiling heights of up to 4.5 m, but uninsulated walls: 36.5 cm perforated brick without external insulation. Hot water from a heat-pump water heater.
Solution: IReWA comfort underfloor heating (full carbon) under tiles.
Costs: The underfloor heating cost €20,000. Quotes for an air-to-water heat pump, gas, oil or pellet heating were €30,000 to €40,000. Because no external insulation was needed, a further approx. €15,000 was saved. According to the sheet, this adds up to €25,000 to €35,000 less investment.
Measured results: Billing period 06.10.2018 to 07.10.2019. Total electricity 14,895 kWh; after deducting household electricity (4,000 kWh), the heat-pump water heater (1,000 kWh) and the sauna (1,000 kWh), 8,895 kWh of heating electricity remain — 40.43 kWh per square metre and year.
In everyday life: Installed in 5 days by 2 tradespeople, dust-free and clean. For conventional water-based systems the sheet assumes 8 to 10 days with the same crew.
Our own house in San Fulgencio, Costa Blanca
Starting point: Detached house built in 1989 in San Fulgencio (Alicante), today the seat of Thermoline Home. Before the renovation, the Spanish energy performance certificate (2019) rated the house class G for energy consumption – 335 kWh per m² and year – and class F for CO₂ emissions at 64 kg per m² and year.
Solution: Renovation in 2022. The external walls were insulated on the inside with ISOFOLIE® reflective insulation behind a drywall lining, and a carbon underfloor heating system (heated parquet) was laid on the floor. The interior walls are painted with Thermoline Interieur.
Result according to the energy certificate after the renovation (2025): class B with 25 kWh per m² and year and 7 kg CO₂ per m² and year – around 93 % less than before.
In everyday life: In our experience, once the radiant heat of the underfloor heating is switched on, the room is pleasantly warm in next to no time.
Energy certificate before and after
| Indicator | Before renovation (2019) | After renovation (2025) |
|---|---|---|
| Energy class consumption | G | B |
| Energy consumption | 335 kWh/m²a | 25 kWh/m²a |
| Energy class emissions | F | B |
| CO₂ emissions | 64 kg/m²a | 7 kg/m²a |
Source: Spanish energy performance certificates (Calificación energética) of the building, registration numbers E2019VI058865 and E2025VA027609. The figures are calculated certificate values, not measured consumption.
From the building site in San Fulgencio
The reference sheets as PDFs
Reference 1: Detached house Litzelsdorf (2021)
PDF · 325.28 KB
Reference 2: Grabenstätt — heated parquet versus heat pump (2021)
PDF · 246.14 KB
Reference 3: Flat in Neusiedl am See (2021)
PDF · 804.28 KB
Reference 4: O.K. Energie Haus Litzelsdorf with photovoltaics (2020)
PDF · 235.05 KB
Reference 5: Detached house Grabenstätt (2020)
PDF · 311.3 KB
Reference 6: Old house St. Michael — heated parquet and district heating (2020)
PDF · 228.85 KB
Reference 7: New build on Lake Constance (2020)
PDF · 279.26 KB
Arrange an introductory call
We look at your house, work through the comparison and tell you which building blocks pay off in your case — and which do not.